On 4/4/18 10:53 AM, [email protected] wrote:
A box wrench or socket for a 3 1/2" nut is not going to be cheap, Grainger
wants over $4000 goo.gl/sgFLVe
This is a case where something like a big pipe wrench or strap wrench
might work well. If using a pipe wrench, I'd pad the jaws so the teeth
don't cut up the bolt. Some scrap steel would work.
For that matter, I wonder if you could get square box tubing that would
fit over the nut.
John KK9A
Wilson Lamb (no callsign) wrote
Soak heavily in magic juice.
Maybe wrap in a rag to maintain concentration of juice.
Get cheap box end or socket wrench.
Make torque pulses with hammer or impact wrench.
Repeat.
It seems like there would be an electrolytic way to do this, but I don't
know it.
WL
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|