Towertalk
[Top] [All Lists]

[TowerTalk] Fwd: Fwd: grounding (again)

To: towertalk@contesting.com
Subject: [TowerTalk] Fwd: Fwd: grounding (again)
From: Hans Hammarquist via TowerTalk <towertalk@contesting.com>
Reply-to: Hans Hammarquist <hanslg@aol.com>
Date: Mon, 23 Apr 2018 19:39:16 -0400
List-post: <mailto:towertalk@contesting.com>
 Yes John,

You are right when it comes to corroded contact point. You have to look up for 
that, mostly because it can give you extra harmonics on your transmission. The 
corroded contact acts like a diode.

I don't think there is much of a problem in case of a lightning hit. The high 
voltage of a lightning will probably not have a problem passing a corroded 
aluminum connection. I do think it will result in larger impact are the total 
voltage from the lightning current will be higher with a corroded contact point 
then without.

Time to check my grounding strap.

73 de,

Hans - N2JFS

 

 

-----Original Message-----
From: john <john@kk9a.com>
To: towertalk <towertalk@contesting.com>
Sent: Mon, Apr 23, 2018 2:58 pm
Subject: [TowerTalk] Fwd: grounding (again)

Aluminum flashing is very inexpensive. I am not sure what effect this has
regarding lightning protection but aluminum is 60% as conductive as
copper. It is also susceptible to connection corrosion issues so using
using conductive grease is important.

John KK9A


Hans Hammarquist wrote:

 Hi Tom,

I am using aluminum straps for my grounding runs. I found 6" wide traps in
the garden department (don't remember what department store it was.
Probably Walmart). The strips are use as edging around flower bads. They
were on sale as it was the end of the season if i remember right. They
came in rolls of 10 feet and have some means to be connected together in
longer runs (although I don't think that connection is of any value from
an electrical point).

I think it's a better idea to use aluminum as you are using an aluminum
plate at each end and there would be less issue regarding possible
corrosion if you use similar material in the plates and the grounding
strip. Aluminum strips are cheaper too, I believe.

Just my 10 cents,

Hans - N2JFS

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>