Thank you for the link. Much more useful to see what everyone is failing to
describe well. Doesn't look like a connector to me :)
73,
Gary K9GS
-------- Original message --------From: jimlux <[email protected]> Date:
6/5/18 6:38 PM (GMT-06:00) To: [email protected] Subject: Re:
[TowerTalk] Replacing station ground J-cord connectors
Cable Gland..
https://www.grainger.com/product/2DPF7
On 6/5/18 2:13 PM, Bob Matthews wrote:
> J-Cord connectors are AKA Strain Relief Connectors. They are used for
> bringing rubber insulated multi-wire cables into fixtures, panels and boxes
> out doors. They have a swaged rubber grommet that pulls tight to the cable
> when compressed by the compression nut.
> Bob KT3RR
>
> Sent from my iPhone
>
>> On Jun 5, 2018, at 17:05, Michael Mathis <[email protected]> wrote:
>>
>> Bob Matthews mentioned using J-cord connectors when passing coax or hardline
>> through box enclosures or panels: What is a J-cord connector?
>>
>> Mike Mathis. N4MIK
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> [email protected]
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|