Good luck finding a base plate. Better re-galvanize it and put a section in
the ground.
There never was Rohn 35. It kinda got that name because dimensionally is in
between 25 and 45.
73
Jim W7RY
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of David
Lowe
Sent: Saturday, September 1, 2018 8:43 PM
To: towertalk@contesting.com
Subject: [TowerTalk] looking for documentation and parts for tower
Looking to find documentation/parts for the tower in the following pictures:
http://we1u.us/ham/ant/895/DSCN5717.JPG
http://we1u.us/ham/ant/895/DSCN5718.JPG
http://we1u.us/ham/ant/895/DSCN5719.JPG
Rohn 35G made for Motorola was suggested.
Was used for the Androscoggin Sheriff Department Repeater in Auburn, Maine
until 2017.
Specifically looking for base hardware.
Thanks in advance
--
Be Well
David Lowe WE1U
68 High St Apt 2
Auburn ME
207 783.1759
http://we1u.us/
GPS: 44.095173N 70.227477W
Google Maps: http://goo.gl/maps/jwrVc
Androscoggin Amateur Radio Club
http://w1npp.org/
WX1GYX SKYWARN
http://www.wx1gyx.org/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|
