Towertalk
[Top] [All Lists]

[TowerTalk] RG179 Chokes For TX 4-Squares

To: towertalk reflector <towertalk@contesting.com>
Subject: [TowerTalk] RG179 Chokes For TX 4-Squares
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Mon, 18 Feb 2019 22:10:25 -0800
List-post: <mailto:towertalk@contesting.com>
After some discussion on one of the reflectors about chokes that could be used in 75 ohm phasing lines, Grant, KZ1W, sent me some. I wound a bunch of chokes using the same methods, and on the same cores, used to produce the new Cookbook, and added winding guidelines for these chokes. They have been added to the latest version of k9yc.com/2018Cookbook.pdf  Refresh your browser to make sure that you've got the latest version. If you have the latest, you'll a a photo of a choke wound with white miniature Teflon coax on page 3.

Note that RG179 has much more loss than RG400, so they have a lot more differential mode dissipation for the same power level. They MUST be exposed to air so that they don't overheat. If used in this manner, they are probably sufficient for use in a 4-square in which power is equally divided between the four antennas, running at legal limit.

What looks like new old stock RG179 is plentiful and cheap ($0.35 - $0.50/ft) on the big auction site from vendors with 100% ratings.

73, Jim K9YC


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>