For my remote station I switch the antennas manually because I have multiple
antennas for multiple bands. I have a KMTronic USB switch connected to my RCS8.
> On Feb 26, 2019, at 12:10 PM, VE6WZ_Steve <[email protected]> wrote:
>
> After posting my video link about TX and RX direction switching, I have
> received some emails asking about how I switch my various transmit antennas.
>
> This morning I built another video that describes my frequency dependant
> switching system that uses the Station Master band decoder.
> What might be unique about the system I use is the requirement to switch
> multiple frequency segments within each band in order to deal with some of my
> narrow bandwidth antennas. I require more than just band switching.
> I discuss the capabilities of the unit, how it is programmed and how I have
> distributed the control lines to the various antennas.
>
> Perhaps this might give some ideas to others with complex antenna switching
> requirements or those planning a remote.
>
> https://youtu.be/n2yR4AU0lkA <https://youtu.be/n2yR4AU0lkA>
>
> 73, de steve ve6wz
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|