Thanks for all the feedback.
I am using Amphenol F Bulkhead Crimp Jacks for RG-179. Part #222114-10.
Greenlee doesn't make a DD punch that small.
I have to drill 14 holes total on several Carlon boxes. And the connectors
are already crimped on the RG-179.
It looks like I have two choices. Make a template for the size and shape.
Drill a small hole. Then use my Rotozip Spiral saw to get the correct size
and shape.
Or drill a .375+" hole, use a few drops of epoxy then put on the washer and
nut and tighten.
I am leaning towards using the Rotozip as then for sure the connector won't
turn and easy to replace if needed.
I had thought there would be something that was off the shelf and not
exorbitant in price to make these type holes.
73,
N2TK, Tony
On 3/11/2019 6:34 PM, tony.kaz--- via TowerTalk wrote:
> Does anyone know of a tool that makes a nice hole in Carlon boxes for
> a female F-connector with two flats that makes a nice hole so the
> connector doesn't spin?
>
> Tnx
>
> N2TK, Tony
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|