Greetings,
As I install my new tower, I was dropping some ground rods next to the
base and acquired some #6 solid copper wire to make the connections (or so I
thought).
When I went to cut the wire I found out that it had a hard core, most
likely steel.
I'm not sure this is plated as the outer copper ring is a substantial
portion of the cross section.
As I'm not familiar with the applicatio of this type of wire I wonder if
it is acceptable for the grounding connection between the tower and the
ground rod?
Thoughts or comments please.
Thank you.
Mike K9MK
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|