Hi,
I will be rebuilding several 4-squares this season as well as restringing them
in different trees due to Tornado damage (loss or destruction of many trees at
my qth) during Tropical Storm Isaias on August 4th. I have a few questions for
which I would appreciate your guidance....
1) If I recall correctly, for purposes of focusing on Europe, ideally I would
want to put the 4 elements in a box formation in the NE, SE, SW and NW
directions relative to the middle of the array. Is that correct?
2) In the 4-square when I select the controller direction NE, I am effectively
radiating broadside NE from the NW and SE elements. Is that correct?
3) In the past I had the bottom of the 4-square elements soldered to center
conductor of the pin of an SO239 with the radials attached to each of the SO239
screw holes, with the coax connector for the phasing line screwed onto the
SO239. (The choke was located below the PL259 on the phasing line) This
worked well but I am trying to improve the design.
If I were to terminate the bottom of the 4-square element by twisting it
through and around one hole of the porcelain insulator and soldering it there,
would I still be able to then solder a small wire from that connection to the
center conductor pin of a SO239 with the radials attached to the SO239 screw
holes as before? My idea being that I can do that then I can use a piece of
twine through the remaining porcelain insulator hole taped to the coax to
provide additional physical support for the coax and radials – which will be
helpful during ice storms.
I would appreciate any thoughts and suggestions and possible improvements on
this design.
Tnx & 73
Bob, KQ2M
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|