MFJ makes the following products:
MFJ-4600, 4602, 4603, and 4605 Window Feedthrough Panel.
I have never used them so cannot recommend. Good luck in your quest.
Semper Fi,
Tommy - K6YE
DX IS and CW RULES
On 2020-11-09 02:40, Jim Pruitt wrote:
I am hoping that someone(s) can give me some advice on cable window
entries. I am looking for something like a 1/4" thick aluminum strip
to go in the window track. The tracks are 38.5 inches apart. I was
unable to find a 4 inch wide aluminum flat bar strip at a reasonable
price ($40 for the strip and $40 for shipping). I did find a 3 inch
wide strip and do have that. What I want to know is what length I need
to cut it to. If I make it the full 38.5 inches long then how do I
get it into the tracks since I can't slide it in from the end? If I
cut it to say 38 inches then what do I use to fill the other 1/2 inch
(or 1/4 inch on each end)? Do I just use stick on weather stripping?
The second part is, how do I make the D shaped holes for the SO239
bulkhead feedthroughs or the UG492 BNC bulkhead feedthroughs? I am
sure my 5/8" Greelee punches will not even make a dent in the strip.
I do not have access to a vertical mill to cut the holes.
Thank you for your help.
Jim Pruitt
WA7DUY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|