Towertalk
[Top] [All Lists]

Re: [TowerTalk] Small mast design - comments?

To: "'Ross Tucker'" <rjtucke@gmail.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Small mast design - comments?
From: "Ron Gorski" <ron-n9au@sbcglobal.net>
Date: Wed, 11 Nov 2020 20:46:48 -0000
List-post: <mailto:towertalk@contesting.com>
No. The 1-1/4 inner tube will not necessarily fit inside the 1-1/2 in tube
because of nominal manufacturing tolerances.
Ron N9AU

-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Ross Tucker
Sent: Wednesday, November 11, 2020 5:51 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Small mast design - comments?

OK, I just submitted an RFQ to Industrial Metal Supply for the following:
Two 12' lengths of 6061 Aluminum tube, 1-1/2" outer diameter, 1/8" wall
thickness.
One 6' length of 6061 Aluminum tube, 1-1/4" outer diameter, 1/4" wall
thickness.

The thick inner tube will be placed inside the joint and pinned. We will use
drive-on steps at the very bottom, a mast bracket at the 2' level, and a
"guy" holding the two masts together over the roofline of the RVs.

Does this sound reasonable? Any additional tips or suggestions before I buy
the materials would be appreciated. Thanks for the help you've already
provided. :-)

Ross, NS7F
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


-- 
This email has been checked for viruses by AVG.
https://www.avg.com

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>