I have a question for the materials crew here. I'm writing up a job report.
Our crew went to a site where a huge tree had fallen on the two lower
guys of a 360' tower. We carefully (well as carefully as we could)
slacked off & disconnected one wire at a time, threw it over the tree,
and reconnected it. At that point the site was ready for the tree crew
to come.
It was obvious that one of the wires (3/8" EHS) had stretched a few
inches. There were enough unused threads in the turnbuckle to enable a
good snug wire again.
I'm recommending that the guy wire be replaced, but was wondering how
much strength in roundabout numbers is lost in this scenario?
TIA
-Steve K8LX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|