Towertalk
[Top] [All Lists]

Re: [TowerTalk] Sealing rotor connectors

To: "'Charles Mills'" <millscl@gmail.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Sealing rotor connectors
From: <maflukey@gmail.com>
Date: Tue, 23 Sep 2025 01:06:51 -0500
List-post: <mailto:towertalk@contesting.com>
Change the terminal strip to a block off plate with a compression fitting to
pass a cable whip through and make the connections in an external junction
box.

Matt
KM5VI

-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Charles
Mills
Sent: Monday, September 22, 2025 8:02 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Sealing rotor connectors

Did some searches and found a few things in the archives but nothing recent
on this.

What does everyone do to seal the rotor cable from the terminal strip on the
bottom of Hygain rotors to keep moisture out and corrosion from forming?

I've been lucky with my previous rather simple setup but I am going to be
doing a rotor swap and would just like to make sure this is the last time I
have to do anything on there for a long time.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>