On 2/10/2026 11:03 AM, Jim Lux wrote:
This is where tools like the NanoVNA are really nice - you can calibrate at the
end of the coax. Or, if you've measured the coax once, you can save it, and
post process your data in one of the apps that takes VNA data (I use
NanoVNA-Saver, but there's lots of others).
A common use of analyzers is to simply use the SWR as a rough indicator
or resonance. The best can export a measurement as a data file (plain
text) that can be imported by freeware like SimSmith, which can then
"tune out" the coax by inserting a length of coax and varying its length
until we see the normal Smith Chart view of resonance. I've used that
model to design switchable stub matching networks for my 80 and 40M
dipoles on the CW and SSB portions of the band. I've also used the model
to optimally place along the line stubs to suppress power amp harmonics,
and to eliminate interaction between harmonically related antennas in
close proximity. See k9yc.com/7QP.pdf for an example.
For more than ten years, I've used the VNWA, built by hams in the UK
based on a design by German EE prof DG8SAQ, and using his control
software. That software can do that transformation and a lot of other
math, like transforming a measurement of an antenna fed by 75 ohm line
to show its true impedance.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|