[AMPS] amp tuning via transceiver control software

[Dave Bernstein]

If you homebrew your transceiver control software, you can easily extend it to display the correct amplifier Tune and Load settings for the current frequency. This enables rapid QSY without marking up your amplifier front-panel. 

Data is stored in a text file, one line per frequency in ascending order. Given the relatively small number of entries (~50), a linear search for the nearest frequency works fine even in Visual Basic on a 386. If you're a perfectionist, you can provide an optimized entry for each 10 kHz segment; alternatively, you can provide a few entries per band and have the software interpolate. The file-driven approach makes it easy to support multiple amplifiers (like your backup).

I thought about adding steppers for the Tune and Load caps, but bandswitching would still be manual.


      Dave
      AA6YQ





--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Sponsored by:             Akorn Access, Inc. & N4VJ / K4AAA