[AMPS] Safety resistor

[measures]

>
>I think Vic is asking about the resistor that goes from the bottom
>of a diode bridge in the P.S. to chassis ground. 

Agreed

>This raises B-
>a few volts above ground so you can measure Ig and Ip in the
>B negitave side. 

Ig, yes.  However, even if the cathode were grounded,  anode-current 
would be metered by connecting the anode-current meter shunt between gnd 
and hv negative. 
>.......

-  Rich..., 805.386.3734, www.vcnet.com/measures.  


--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm