[AMPS] FS: SB-200 conversion to 3CX800A7 project

[Norman Hockler]

Guy's...

Started this project some time ago but I just cant get the time to finish 
it (business picked up finally).
Gathered most of the parts.  The tank coil needs wound (1/8" copper tube) 
and there are some odds and ends necessary to complete the parts list (disk 
ceramics, etc)

What I have is:

  Clean SB-200 with the band switch and all the tank circuit removed
  The original front panel and a new front panel cut for the meter and the
  new caps
  Original meter and knobs
  The tune cap
  The load cap
  blocking caps
  two required chokes
  A good 3cx800a7 with socket and chimney
  Filament TX for the tube
  ARRL 92 HB article for 6M amp using this tube

The 3cx800a7 socket will fit in one of the 572B holes.
The HV power supply is more than adequate

Cost $595 plus shipping

Norm  N8NH



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com