[Amps] ts-930 relay

[Steve Katz]

Pins 2&4 ought to work fine.  I don't even recall the "jumper" in the TS930,
it's been too many years ago for me.  My more modern TS850S uses the same
"REMOTE" 7-pin DIN connector, and to enable the amplifier keying relay,
there's a small switch on the rear panel.  Pin 7 is not a relay output, it's
a keying line input in Kenwoods, far as I know.

Do you have the 930S manual, so you can find the "jumper?"  That's probably
all that's needed.  The Kenwoods key the AL80B just fine, as far as I know.
My TS850S easily keys it, but the switch must be in the correct position!

WB2WIK/6

"If everything seems under control, you're just not going fast enough." -
Mario Andretti

> -----Original Message-----
> From:	Marcel Jorba [SMTP:mjorba@ingelan.com]
> Sent:	Monday, July 29, 2002 10:51 AM
> To:	amps@contesting.com
> Subject:	[Amps] ts-930 relay
> 
> I need to use an AL-80A linear together with a TS-930.
>  
> My problem is that the pinout for the relay doesnt switches the linear
> (using 2 and 4 pins on the remote connector) because no enough current is
> driven (I guess).
> I believe that pin 7 offers a relay output but it dosen't work for me. How
> can I know if the relay is included in my unit? (s/n is 5xxxx). A guy told
> me that a jumper enables/disables the T/R relay.
>  
> ANy help?
>  
> Thanks
>  
> Marcel, EA3IN
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps