[Amps] KNOB ORIENTATION

[Steve Katz]

I think it's not a matter of "should" or "should not," but most appliances
having such a control are labeled "100" when the plates are fully UN-meshed
(minimum capacitance), by convention.

WB2WIK/6

"Success is the ability to go from failure to failure with no loss of
enthusiasm." -Winston Churchill

> -----Original Message-----
> From:	W0YR at aol.com [SMTP:W0YR at aol.com]
> Sent:	Monday, February 24, 2003 3:19 PM
> To:	amps at contesting.com
> Subject:	[Amps] KNOB ORIENTATION
> 
> Can someone please clarify:
> 
> Should the pointer on knob of an antenna loading capacitor shaft point to
> 100 
> when the plates are fully meshed, or should it point to zero?
> 
> 
> 
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps