[Amps] Rm resistor
R.Measures
r at somis.org
Tue Dec 14 07:11:16 EST 2004
This applies to grid-driven Class AB1 amplifiers when they are being
neutralized, but not to g-g Class AB2 amplifiers.
On Dec 14, 2004, at 1:16 AM, Steve Thompson wrote:
> On Monday 13 December 2004 20:26, Luca wrote:
>> Hi All
>>
>> For the Pi or PiL adjustaiment whit the swr analyzer ,it's necessary
>> to
>> place a non-inductive resistor egual to the plate impedance,from the
>> anode
>> tube and the chassis ground. I would like to know if in the PiL case
>> ,for
>> the best result, it's necessary to place also the non-inductive
>> resistor
>> egual to RM value ,for example 300 ohm, from the load variable
>> capacitor to
>> the chassis ground.
> No. The resistor from the anode to ground is the only one you need.
>
> Steve
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
More information about the Amps
mailing list