[Amps] Filament Transformer

[carl seyersdahl]

Use them , but make sure they are phased properly or the voltage will be too
low.!!!
     carl / kz5ca
----- Original Message ----- 
From: "David C. Hallam" <dhallam at rapidsys.com>
To: <amps at contesting.com>
Sent: Sunday, June 20, 2004 10:50 AM
Subject: [Amps] Filament Transformer


> I am building a linear using a 4CX1500A that needs about 38 amps at 5
volts
> for the filament.  I have two identical 5V 21A filament transformers.  Is
> there any reason why I can't wire the two in parallel to get the required
> amperage the filament?  I would put a current inrush limiter for a soft
> start.
>
> David C. Hallam KC2JD
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>