[Amps] Semtech?
Web Williams
kr4wm at earthlink.net
Mon Oct 25 10:46:36 EDT 2004
Hi Richard,
Can you tell me the technical explanation (in an "Idiot's guide to"
method) as
to why a conventional diode tester (that shows .6xx voltage across an
ordinary
silicon diode) will not show any indication across these diodes? Are
they not
just plain old standard diodes? What's inside the modules? Just
curious... and
I bet you've "been there, done that"?
Thanks, -Web
R. Measures wrote:
> FWD: Apply c. 14vdc, in series with 20 - 500 ohms, with pos. to the
> anode-end. V-drop should be approximately 7V for a 10KPIV unit.
> REV: Connect to high pot tester with neg. on anode-end. Slowly
> increase inverse voltage until 2 uA flows. This is the actual piv.
>
> cheers, Web
More information about the Amps
mailing list