[Amps] AC wiring
Keith Dutson
kdutson at sbcglobal.net
Fri Oct 21 16:30:30 EDT 2005
The receptacle was rated for 30 amps also.
_____
From: Gudguyham at aol.com [mailto:Gudguyham at aol.com]
Sent: Friday, October 21, 2005 3:25 PM
To: kdutson at sbcglobal.net; amps at contesting.com
Subject: Re: [Amps] AC wiring
In a message dated 10/20/2005 9:53:16 AM Eastern Daylight Time,
kdutson at sbcglobal.net writes:
I agree with you Tony. I ran a new 240 VAC circuit for my Alpha which
specifies 20A. I used 10 AWG for the run to ensure least voltage drop over
the 100 foot path from the mains panel and put it on a 30A breaker. I think
the difference in cost from 14 AWG wire and 20A breaker was less than $5.
This was back in 1995, so the cost difference is likely a bit higher now
with increased cost of copper.
OK, so you ran a #10 wire and put a 30 amp breaker on it and you plugged
your Aplha into that circuit. What rating was the recepticle you install on
the #10 wire with the 30A breaker?
More information about the Amps
mailing list