[Amps] High voltage connectors > 5kV rated working voltage for PS to RF deck connection _

[Bill Turner]

A previous poster wrote:

>While finishing my separated PS chassis now the question is which
> > connectors to take for running B+ / B- to the RF deck ...
> > I'd like to use a model which is save up to 10kV, but has at least a
> > rating of 5 kV DC. I know the Huber+Suhner SHV series but these are
> > at the limits with 5 kV DC. Any other suggestions that have the same
> > mechanical quality as the HuSu SHV type?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

This doesn't really answer your question, but is something to consider.

I don't use HV connectors at all. My amp is hard-wired directly from 
power supply to amplifier. Unless you plan on connecting and 
disconnecting a lot, a direct connection without connectors is 
cheaper and safer, IMO. I have a ceramic standoff insulator on both 
p/s and amp and just run a HV wire between the two. Of course you 
must be sure the HV capacitors have fully discharged, but that's true 
using a connector, too.

Connectors are always a potential source of trouble and I try to 
eliminate them wherever possible.

73, Bill W6WRT