[Amps] Cutting G-10 Board

[Steve Thompson]

Bob Maser wrote:
> Does anyone has advice on how to make straight cuts on 1/8" G-10 board 
> material(actually, it is G-11 but very close to being the same as G-10)?  I 
> am building a plenum for a MLA-2500 and want straight cuts to allow for 
> minimum air gaps in the joints.
If there's a pcb shop local to you, ask nicely if they will do some cuts 
on their guillotine. A few coins in the coffee fund is often enough 
payment. Their scrap bin is a good source of material too.

Steve