[Amps] L4-B Power Supply

[Gudguyham at aol.com]

In a message dated 7/4/2006 11:15:36 A.M. Eastern Standard Time,  
radio_k4rv at peoplepc.com writes:

Most of  the capacitor choices I found were of the type using snap in  
terminals.  Into what do these terminals snap?  Can I just mount  the 
capacitors and then solder leads to their snap in terminals, or is  there a 
snap in receptacle of some sort available?

Thanks
Tom  K4RV 



Tom, I have rebuilt a few L4B power supplies,  I use 390mfd/450v snap  in 
caps(which I sell for $2.50 each) I drill small holes in the original circuit  
board and fit the snap in caps tightly in the holes and then solder point to  
point wiring to them.  If you are interested in purchasing some of my caps  send 
me an e-mail off list.  Thanks 73 Lou