[Amps] QEX Innovative Tube Linear?

[Tom W8JI]

>I just looked at the curves for several sweep tubes 
>including the ones I mentioned, and they didn't start to 
>bend until around 250 Vdc and below. They were flat from 
>there on up in voltage until the maximum permissable anode 
>voltage rating. Running them just at or below the maximum 
>permissable anode voltage would be recommended. Some 
>designers of the past tried to run them at a much greater 
>anode voltage than what the spec sheets say is permissable. 
>I'll try to post the different maximum anode voltages later 
>this evening.

Do you actually have an application sheet for these tubes in 
linear amplifier service Will?

73 Tom