[Amps] 200 Watt Fast Relay

David Cutter d.cutter at ntlworld.com
Tue Jul 10 18:57:50 EDT 2007


I once had to design an equipment with a switch with a very variable contact 
resistance.  I made it work successfully by ensuring a small dc current 
passed thro the contacts on closure and this was enough to break down the 
surface film.

I've often wondered if this could be applied to relays looking for sub uV 
signals to make them more tolerant to ageing:  in QSK, 1M ops is not a big 
number.

David
G3UNA

----- Original Message ----- 
From: "Tom W8JI" <w8ji at w8ji.com>
To: <amps at contesting.com>; "Bill Fuqua" <wlfuqu00 at uky.edu>
Sent: Tuesday, July 10, 2007 10:58 PM
Subject: Re: [Amps] 200 Watt Fast Relay


>> Here is a problem I have with relay specifications.
>> Usually, for weak
>> signal applications we use gold plated contact switches
>> and relays. Since
>> most relays or switches are normally exposed to air,
>> oxidation can form and
>> weak signals can't always be conducted between them.
>
> Unfortunately you can use any plating you like and a
> percentage of relays will eventually mess up if it has
> exposure to "air".
>
> The most common problem for sealed relays (not vacuum, just
> enclosed) is contamination caused by the materials in the
> relay. It's a tiny layer just a few molecules thick.
>
> That's why the contacts have to wipe, or have a small amount
> of current when closing.
>
> Vacuum relays cure that problem.
>
> 73 Tom
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps 



More information about the Amps mailing list