[Amps] Dummy Load DA-174/GRM-10

Keith Schreiber schreiber at alltel.net
Wed Jul 18 18:21:07 EDT 2007


Greetings to the group!

I'm trying to trace down a schematic or any info on the following item :

Dummy Load, Electrical  DA-174/GRM-10

I've not been able to find anything about it on the net.  This gizmo has a Simpson 0-10 RF Ammeter on the front, a squirrel cage blower (with switch & pilot light) that cools many 20 watt, wire-wound resistors.  These resistors are all mounted in a phenolic box, which the blower forces air through, and then out the back.  The cabinet is filled with all kinds of fixed inductors and 850 series doorknob caps.  The dimensions are roughly 9" wide  X  10" high  X  15" deep.  The input is a female N connector.  The input connector and the 0-10A RF ammeter are mounted on a 1/4" thick phenolic plate (on the front panel.)  The cabinet itself is all aluminum, with screened vents on the left side and the rear.  It's gray in color.  The front panel also has a fuse for the blower and a black, 5-way binding post for a ground connection, in the lower left corner.

This is the first time the web has let me down in finding info on something.  The only info I was able to find on this item, was it's NSN (National Stock Number) :

5985-01-261-4595

>From that number, I've seen references that it was made by Rockwell-Collins at some division in Richardson, TX.  I've got a number called a "CAGE" number too.... if that means anything to anybody. (80058)

I'd appreciate any info, that anyone could provide.  Perhaps you used one of these in your military days.  I don't even know the frequency range.  It will not accept power (SWR=19) and an ohmmeter applied to the center pin of the N connector, shows "open" to ground.  No doubt one of the many 20W wire-wound resistors that actually make up the load is open.  But the way this thing is put together, it's going to be a real chore finding out which one.  Especially without a schematic.

Any info on this?  I guess it would be best to reply to my regular e-mail    schreiber at alltel.net

Thanks & 73 from W8KTH
Keith


More information about the Amps mailing list