[Amps] Radio Switch/Multi-Tech

[Scott McGrath]

Drive punches and V-blocks

You need to set up a support on the shaft between the wafers and drive 
out the pins with either a small arbor press or HIGH QUALITY punches
think Starrett not Harbor Freight.     HF V blocks would be Ok as you 
will need to cut them to fit.

- Scott


N7KA at comcast.net wrote:
> What are the SUCCESSFUL techniques for removing the pin in the rotor of these switches?  IF YOU HAVE SUCCESSFULLY removed these pins I would like to know how it was done and what tools were used.  I have some Model 86 switches I WANT to build/rebuild for use. 
>
>
>
> Arne N7KA 
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>