[Amps] RF ?

[Francis Sanita]

I have a question I would like to put out for discussion.

After using my SB 200 I notice that my Genie garage door opener will  
not work. The opener has a control board that searches for new  
frequency codes as a security feature. The control board apparently  
shuts down and I must unplug the opener and re plug to reset it.

I have not eliminated this issue to any particular band and no other  
equipment in my shack affects the garage door opener ( not even my  
30L-1). The door issue does not occur when the amp is not used and can  
run smoothly until the amp is put into use again so I feel the amp is  
the cause.

Before I start tearing things apart - has anyone experienced similar  
issues or have suggestions as to how to proceed.

Thank you.

Frank Sanita AA4FS
Palm Coast, Fl 32164
fsanita at cfl.rr.com