[Amps] RF ?

[Glen Zook]

Try ferrite on the power cord and/or some bypass capacitors.  What you are seeing is pretty common and can often occur even when much lower power is run.  Many alarm systems in houses are often affected by such as well.

Glen, K9STH

Website:  http://k9sth.com


--- On Wed, 2/4/09, Francis Sanita <fsanita at cfl.rr.com> wrote:

After using my SB 200 I notice that my Genie garage door opener will not work. The opener has a control board that searches for new frequency codes as a security feature. The control board apparently shuts down and I must unplug the opener and re plug to reset it.
 
I have not eliminated this issue to any particular band and no other equipment in my shack affects the garage door opener ( not even my 30L-1). The door issue does not occur when the amp is not used and can run smoothly until the amp is put into use again so I feel the amp is the cause.
 
Before I start tearing things apart - has anyone experienced similar issues or have suggestions as to how to proceed.