[Amps] Question about large solid-state HV rectifier - ratings plus any value????
Randy.Randall at healthall.com
Mon Jun 8 12:21:06 PDT 2009
Don't forget TungSol. They made some semiconductors in the past and were a mil contractor. Might be part of some industrial line of semi's.
From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com] On Behalf Of Robert Groh
Sent: Monday, June 08, 2009 2:16 PM
To: amps at contesting.com
Subject: [Amps] Question about large solid-state HV rectifier - ratings plus any value????
Finally tearing down the old homebrew KW amplifiers I bought a good many years ago. This has lead to a few '..what the heck is that... and '...maybe I should just pitch that ....' type of questions. This is the first of a few which I would like to post to the list for their knowledge and expertise.
The PS (setup for about 6 KV or so) used a bridge rectifier arrangement. The each rectifier element is a black, cast cylindrical rod about 9" long and about 1-1/8" in diameter. Electrical connections at each end: a screw at the anode end and a stud at the cathode end. The manufacturer uses a lower case t followed by an s (i.e. ts) and the only part number is 'TM1-10H-X165' followed by 'F6'.
This is obviously a early (i.e. 1970s or 1980s) packaged HV, silicon diode (most likely), rectifier diode.
I would like to:
#1 Know what ratings it might have
#2 Know if they (I have the four) have any value to anyone. Otherwise they are subject to being pitched.
Thanks for your time!
Amps mailing list
Amps at contesting.com
Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.
More information about the Amps