[Amps] Meter shunt

Steve Katz stevek at jmr.com
Fri May 29 10:09:45 PDT 2009


Surely, this depends on the meter.  It's easy enough to measure and find out.

Most of my "1mA" to "100mA" meters here (Simpsons, Westons) have those shunts built in.

"1A" and higher meters almost always don't!

WB2WIK/6

-----Original Message-----
From: amps-bounces at contesting.com [mailto:amps-bounces at contesting.com]On
Behalf Of Ron Youvan
Sent: Friday, May 29, 2009 10:03 AM
To: amps
Subject: Re: [Amps] Meter shunt


> If the meter's already scaled 100mA, why not just use it as it is?
> It probably already contains the correct shunt to make it 100mA full scale.
> Have you measured it to see what it actually reads?

   Usually, but not always, meter cards (scale) will indicate the meter movement 
sensitivity in the lowest right hand location on the card, normally in a hard to see 
location.  Like a 10 mA scale might say 50ua in the corner of the card.
Most good Voltage and current meters with over 1 (or so) mA (scale) will expect a 
multiplier or shunt to operate at the scale value.
-- 
    Ron  KA4INM - No Micro$oft Products were used in sending this e-mail.
                                                 (or any since June 1997)
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps


More information about the Amps mailing list