[Amps] HV lytic max V ratings..some notes.
Roger
sub1 at rogerhalstead.com
Sat Apr 10 13:39:45 PDT 2010
Carl,
What do you use for spike suppression and where do you put it? Across
each cap? Across the transformer primary?
Carl wrote:
> I get a bit carried away with spike suppression and fault limiting. Had an
> amp blow on me about 40 years ago and said never again!
>
> Carl
> KM1H
>
>
>
>
>> Thanks, that's what I usually hear when I look into electrolytics.
>>
>> And I think you hit the nail on the head with spike suppression...that may
>> be the reason that operating with a safety margin is recommended. Most HV
>> PS
>> designs I have come across (in my admittedly limited experience) do not
>> have
>> any kind of protection.
>>
>> 73, Carl WS7L
>>
>>
>>> -----Original Message-----
>>> From: Carl [mailto:km1h at jeremy.mv.com]
>>>
>>> IMO the only rule is the heat rise.
>>> ...
>>> This also assumes spike suppression is used.
>>>
>> _______________________________________________
>> Amps mailing list
>> Amps at contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
More information about the Amps
mailing list