[Amps] Can I cool too much the tubes?

Bill, W6WRT dezrat1242 at yahoo.com
Wed Aug 18 13:49:26 PDT 2010


ORIGINAL MESSAGE:

On Wed, 18 Aug 2010 16:08:12 -0400, Roger <sub1 at rogerhalstead.com>
wrote:

>The transformer ratings/temp are another important point. 

REPLY:

Good point. I know in my SB-1000 the transformer is the limiting
factor in continuous carrier (RTTY) operation, not the tube. Could be
the same for Ten-Tec. 

My rule of thumb (finger) is if the transformer is too hot to touch,
it's too hot to run. Transformers are made of materials that are much
less heat-tolerant than tubes or resistors, for example. 

73, Bill W6WRT


More information about the Amps mailing list