[Amps] Need help with ARD 230A

[k3rww at comcast.net]

----- Original Message ----- 
From: k3rww at comcast.net 
To: amps at contesting.com 
Sent: Sunday, January 17, 2010 5:57:15 PM (GMT-0500) Auto-Detected 
Subject: Re:Need help with ARD 230A 


Hello 

I could use some help with this ARD-230A .If someone out there has worked on 230A ,the problem is as follows .After the initial warm up time period the "not ready" light remains on.If I put the amp in manual mode,it still stays on.At no point in manual mode will the Tune/Load motors move up or down.I suspect that the EPROM has dumped/lost its memory.Any help would be appreciated.Thanks 

Leslie;K3RWW