[Amps] Clipperton-L parasitic suppressors

[Larry]

I may have tried it WARC bands at some point but that would have been long 
ago. I do not
currently have any WARC band antennas. My Clipperton-L also has an added 
tuned input
board which does not include WARC bands and would make it difficult to 
operate. The tuned
input board was added after any WARC band trial. My TS940 didn't mind the 
untuned input
but when it died I switched to a TS2000 which was much happier with the 
tuned input.

73, Larry  W6NWS
----- Original Message ----- 
From: "Cecil Acuff" <chacuff at cableone.net>
To: "Larry" <w6nws at arrl.net>
Sent: Friday, March 12, 2010 5:54 PM
Subject: Re: [Amps] Clipperton-L parasitic suppressors


> Larry I replaced mine with the neat board made by Ameritron for their 
> AL-572 amp.  Also put their plate choke in.  Solves a lot of problems with 
> the original design.  Allows use on the WARC bands without going up in 
> smoke which may be what happend with yours.  10M use seems to heat them as 
> well...
>
> The Ameritron parts solves it all and the stuff is pretty cheap.
>
> Cecil Acuff
> K5DL
> ----- Original Message ----- 
> From: "Larry" <lknain at nc.rr.com>
> To: "Amps" <amps at contesting.com>
> Sent: Friday, March 12, 2010 3:33 PM
> Subject: [Amps] Clipperton-L parasitic suppressors
>
>
>>I have cleverly filed my Clipperton-L doc. I am hoping someone can help. 
>>The parasitic
>> suppressor resistors have broken. I believe they are 100 ohm 2W 
>> composition. Can
>> anyone confirm the value? I am not sure what caused the breakage at this 
>> point.
>>
>> 73, Larry  W6NWS
>> _______________________________________________
>> Amps mailing list
>> Amps at contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>