[Amps] New NXP BLF578XR 1200W LDMOS FET is "indestructible"

Paul Decker kg7hf at comcast.net
Fri Jul 22 15:07:33 PDT 2011





Well that is exactly my point.  I think with power mosfets, the drain is usually part of the outside package.  The physical parts of the tube is small, the cooler is just an external part.  case and point are the russion tubes where you can change anode coolers to change dissipation.   It would seem to me that cooling either shouldn't pose a problem as they are both about the same physical size.  The difference is the tube engineers have built in the cooling system while the transistor engineers have left it as an exercise for the students to design the cooling system. 







----- Original Message -----


From: "Al Kozakiewicz" <akozak at hourglass.com> 
To: "Paul Decker" <kg7hf at comcast.net>, amps at contesting.com 
Sent: Friday, July 22, 2011 4:32:13 PM 
Subject: RE: [Amps] New NXP BLF578XR 1200W LDMOS FET is "indestructible" 

The anode cooler is welded to the outside of the anode. The ceramic is just an insulator that isolates the anode from the socket and does not much factor into cooling the tube.  I have an 8877 in my hand right now - the anode is a metal cylinder that's about 2" in diameter and about 2" long.   It has a lot of thermal mass compared to a power MOSFET transistor, where the silicon is maybe .125 or so inches square.  The package is inert and much larger than the actual device, whereas with a tube the package is part of the actual device. 

Al 
AB2ZY 

________________________________________ 
From: amps-bounces at contesting.com [amps-bounces at contesting.com] On Behalf Of Paul Decker [kg7hf at comcast.net] 
Sent: Friday, July 22, 2011 4:16 PM 
To: amps at contesting.com 
Subject: Re: [Amps] New NXP BLF578XR 1200W LDMOS FET is "indestructible" 

Over the years I've heard many people say that adequately cooling a transistor is difficult because it is so small.  It's really difficult for me to wrap my brain around that statement though after playing with the 3cx400A7/3cx800A7 series tubes.  If one were to take the anode cooler off the tube, they would end up with a piece of ceramic about 1.4" in diameter and about .75" high.  This is on par with the size of these transistors.   It seems to me the dissipated power per area is roughly the same when looking at the devices minus their coolers.  What would be interesting is if a transistor manufacturer took a page from the tube world and integrated similar cooling. 





_______________________________________________ 
Amps mailing list 
Amps at contesting.com 
http://lists.contesting.com/mailman/listinfo/amps


More information about the Amps mailing list