[Amps] Getting a blower out of the shack

[Gary K9GS]

A store that sells woodworking equipment is your best bet.

Try rockler.com or woodcraft.com

Look under "dust collection".  Both have stores...perhaps near where you 
live.



Also try Home Depot or Lowes.  They carry different sizes of dryer hoses 
and fittings to go with them.




On 4/9/2013 4:14 PM, Rick Stealey wrote:
> I have a homebrew amp with a blower mounted on the back of the chassis.  The blower has a flat flange, and the chassis has a rectangular hole cut in it to match.
> What I would like to do, to reduce blower noise, is to remote the blower about 6 feet away (actually into the basement immediately below the amplifier rack.)
> I need a means of converting the blower flange to a round hose, and the compliment of that at the amplifier.  I will run the 6 feet of hose through the sheetrock wall, and down through the sole plate into the basement, so the maximum hose diameter is 3.5 inches (it will go through a 2 X 4 sole plate).
> Any ideas where to get parts I would need?
>
> Rick  K2XT
>   		 	   		
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>

-- 


73,

Gary K9GS

Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
CW Ops #1032   http://www.cwops.org

************************************************