[Amps] Getting a blower out of the shack
Carl
km1h at jeremy.mv.com
Tue Apr 9 21:10:50 EDT 2013
I would consider a dryer hose since they come in several sizes and have
various sheetmetal ends that go to the outside vent. Mine is square.
I see no need for anything high priced since temperature is low as is the
air pressure.
Carl
KM1H
----- Original Message -----
From: "Rick Stealey" <rstealey at hotmail.com>
To: <amps at contesting.com>
Sent: Tuesday, April 09, 2013 5:14 PM
Subject: [Amps] Getting a blower out of the shack
>I have a homebrew amp with a blower mounted on the back of the chassis.
>The blower has a flat flange, and the chassis has a rectangular hole cut in
>it to match.
> What I would like to do, to reduce blower noise, is to remote the blower
> about 6 feet away (actually into the basement immediately below the
> amplifier rack.)
> I need a means of converting the blower flange to a round hose, and the
> compliment of that at the amplifier. I will run the 6 feet of hose
> through the sheetrock wall, and down through the sole plate into the
> basement, so the maximum hose diameter is 3.5 inches (it will go through a
> 2 X 4 sole plate).
> Any ideas where to get parts I would need?
>
> Rick K2XT
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1430 / Virus Database: 2641/5734 - Release Date: 04/09/13
>
More information about the Amps
mailing list