[Amps] Henry 3002 help

[Carl]

Thats what I figured Don as there is a lot of range in that tuning. Henry 
did the same with their 8874 paging amps and was not known to reinvent 
things if not required.

Tweak that input cap and then bring up the drive to no more than 75W while 
watching grid current. A good tube will reach full output well below the 
spec sheet while a well used one needs more drive and current.

Carl
KM1H




----- Original Message ----- 
From: "Donald Fox" <taurusshoguy at yahoo.com>
To: <amps at contesting.com>
Sent: Thursday, January 31, 2013 1:39 PM
Subject: [Amps] Henry 3002 help


> Carl and Colin:
>
> I have done some checking by comparing the measurements of the two output 
> plate lines against measurements from a fellow 3002 owner. The result was 
> that they appear to be identical.
>
> As you might imagine, the output plate line is all silver plated and very 
> "elegant" looking as the Henry advertisement used to say.
> The output tune/load caps are plates with teflon sandwiched between them 
> and the tube plate assembly.
>
> I viewing the input circuit, it consists of two small coils of varnished 
> wire and a small bread slicer cap.
>
> If you guys saw this thing, I think you would agree that it was extremely 
> well cared for considering the use was commercial and not Amateur.
>
> If you recall, the blower was one item that needed attention when I got it 
> so the motor has been replaced. I did post my parts/info on that here so 
> others with Henry consoles might make future use of it.
>
> I will do some further testing and report back with my collected data.
> Thanks to the collective wisdom here for any and all future help.
>
>                    Don    N8ECH
>
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1430 / Virus Database: 2639/5572 - Release Date: 01/31/13
>