[Amps] Question on soft start board location on a SB1000

[Jim W7RY]

I just installed one of my step starts into an SB-1000. I used a 6-32 
standoff about 1 inch long. I removed the nut on the screw holding the 
ground wire from the power cord to the chassis. Then installed the the 
standoff. Installed the board on the standoff.

Not sure if the Harbauch board has holes for mounting or not.

73
Jim W7RY


On 11/7/2013 10:43 AM, Mike Krzystyniak wrote:
>     I am installing a Harback SS-100 into a SB-1000 for a friend.  The instructions suggest it be glued in place with some RTV or something similar.  I was thinking contact cement or maybe double sticky tape?
>   
>     Also, looking around inside there are not a lot of choices on where to afix it.  One possibility is the top surface of the power XFMR, or taking the back panel off there appears to be room below the antenna jacks.
>   
>     I was wondering if anyone on the list has installed one of these on their SB1000, how and where did you install yours?
>   
> Thanks in advance.
>   
> Mike K9MK
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>