[Amps] Remote monitoring of SSPA

[Conrad Farlow]

I have been asked to look into the possibility of remote monitoring an 
SSPA at a distance of a little over 50m. My feelings are that ethernet 
is the way to go. I will need to monitor supply voltage and current, 
forward and reflected power, drive power and a few fault conditions. Are 
there any ready made configurable solutions all ready out there?

I do not expect there to be problems with RF fields as it is a 1kW on 
23cms and there should not be much spill over from the dish. Of course 
it must be quiet so as to not disturb the weak signal RX.

Any advice appreciated.

-- 

__________________________________________________

73

Conrad G0RUZ IO93FR


North Wakefield Radio Club

__________________________________________________