[Amps] L-C-L vs C-L-C

[chris at chrishays.com]

Another reason I suspect is the C-L-C pi network allows both the variable
capacitor rotors to be at ground potential.  This lets the shaft be at
ground potential making for a safer control that is not affected by the
proximity of the human operator's hand. No insulated shaft required either!

Chris, AB6QK



>
>Is there any particular reason the L-C-L T-match is better or worse than
>the more standard C-L-C pi network in this application ?
>
>Thanks,
>Steve, N2IC

>REPLY:

>In order to achieve a wide range of impedance matching, you need to
>have two of the three elements variable. Variable capacitors are
>preferred by most designers over variable inductors for reasons of
>cost, wider range of adjustment and availability. Aside from those
>constraints, either circuit will do the job.

>73, Bill W6WRT


------------------------------

Subject: Digest Footer

_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps


------------------------------

End of Amps Digest, Vol 151, Issue 8
************************************