[Amps] 4CX1000a test and gettering

[MU 4CX250B]

Ed, the best place to test it is in your Acom amp itself! Just run it
for a few hours with filament on but offline and no RF drive. It
doesn’t matter if the high voltage is also on, so long as the
amplifier is off-line.With a newEimac tube I doubt there’s any
preconditioning required at all.
73,
Jim W8ZR

Sent from my iPhone

> On Jun 14, 2019, at 10:20 AM, Edward stallman <ed.n5dg at gmail.com> wrote:
>
> I bought a NOS Eimac 4CX1000a . Looking at the tube, ir shows no signs it has been used. Is their a place I can send the tube  to have it Gettered and tested before installing in my Acom 2100 amp ?
>
> Tnx Ed N5DG
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps