[Amps] Henry 2K-4 Failure
Mark - N5OT
r-emails at n5ot.com
Thu Mar 19 20:31:09 EDT 2020
This is getting more and more exciting all the time. Stay tuned. So to
speak.
73 - Mark N5OT
On 3/19/2020 5:45 PM, VE1DT wrote:
>
> Hey Jim & Mark,
>
> Stayed failed to me means that the sucker is welded.
>
> How do I know this for certain ,you ask? My new AL80B became
> intermittent within the first few months after getting it. The grid
> meter was pegged negative at the zero end. After a few more times, it
> finally stayed failed. I pulled out the tube and measured a short on
> the pins of the tube. Easy peasy. I had a VOM, but no spare tubes to
> swap with.
>
> I am sure there are intermittent cases out there as well.
>
> --
>
> Gerald, VE1DT
>
> >/Grid to cathode short & ?stayed failed? means you just need an /
>
> >/ohmmeter. No need to swap tubes, etc./
>
> >
>
> >/Gerald, VE1DT/
>
> >
>
> ## Nope. The grid to cathode short only happens with tube fil
>
> lit..... not when cold.
>
> When cold, both a HI pot tester.... and also a megger wont work
>
> either.
>
> Jim VE7RF
>
More information about the Amps
mailing list