[Amps] 300Hz sidebands
Jim
jimw7ry at gmail.com
Tue May 25 21:25:34 EDT 2021
What about a different amplifier power supply.
What about a different supply (or battery) for the exciter?
Thanks
73
Jim W7RY
On 5/24/2021 1:09 PM, Conrad PA5Y wrote:
> Hello Geert.
>
> Yes, I did try 3 different drivers, and several amplifiers off this HT supply. The same result.
>
> K3S>transverter>driver amp> PA
> TS2000
> IC746
>
> Same result.
>
> I eventually got the supply out of the rack and took the lid off. The reason for the sidebands was quite obvious, a previous owner had removed the HT choke, I also tested the 8uF cap, it was 7.85uF my DER EE DE 5000 LCR meter. The original choke will be sent to me this week. These sidebands have been there for the 5 years that I have run this amp.
>
> Regards
>
> Conrad PA5Y
>
> -----Original Message-----
> From: Amps <amps-bounces at contesting.com> On Behalf Of Geert Jan de Groot
> Sent: 24 May 2021 19:53
> To: amps at contesting.com
> Subject: Re: [Amps] 300Hz sidebands
>
> On 23/05/2021 20:52, amps-request at contesting.com wrote:
>> I have several tetrode amplifiers that run from a 3PH 50Hz supply. With the advent of the FT8 I have become aware that I have 300Hz sidebands at only -50dBc, this is obviously unacceptable.
> Apologies for asking, but have you tried a different driver transceiver to see if the signal (level and/or frequency) changes?
>
> Geert Jan
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
More information about the Amps
mailing list