[Amps] 10 kw CCS on 6M. Part-3

[Michael Tope]

There was a similar amplifier for sale on QTH.com a while back. The 
seller was a 6 meter EME enthusiast who appeared to be in the process of 
downsizing. I suppose with one of those amps on each end of a link and 
lots of aluminum in the air on both ends, you could ragchew on SSB with 
your counterpart using 6 meter EME :-)

73, Mike W4EF...................

On 9/9/2022 5:29 AM, Pete Smith N4ZR wrote:
> OK, I give up - what's the point of 10 KW CCS?
>
> 73, Pete N4ZR
> Check out the new Reverse Beacon Network
> web server at<https://reversebeacon.net>.
> For spots, please use your favorite
> "retail" DX cluster.
>
> On 9/9/2022 1:39 AM, jim.thom jim.thom at telus.net wrote:
>> 10 kw CCS on 6M..using the 3CX-6000A7.
>>
>>
>> Ok, here's the 3rd installment of this project.
>>
>> Here, the socket and chimney are installed. Due to space constraints, 
>> the
>> tube is in the corner. To get around piling on more stray C ..between 
>> side
>> / rear wall..and anode, I had him space the anode 2.5" away from 
>> both. When
>> the space is say doubled, the C will drop to just 1/4. Same deal with
>> spacing between stator + rotor plates on an air variable.
>>
>> Also note, instead of using machine screws to mount the .515" thick 
>> chimney
>> to the chassis...threaded studs were used instead. Studs screwed into 
>> the
>> teflon. Then chimney + studs dropped onto chassis. It's another way of
>> doing it. If mounting the chimney to the top lid, it's actually much
>> quicker using the studs.
>> https://www.youtube.com/watch?v=RBIT76-o6tM
>> <https://www.youtube.com/watch?v=RBIT76-o6tM&fbclid=IwAR10CtUWkUQ-LTRBvq6StAPbI2dhthPZTW5815ahAeuSY2t3I0ki02JF0vQ> 
>>
>> _______________________________________________
>> Amps mailing list
>> Amps at contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps