[CQ-Contest] Pin the TH7 on the tower

Jim White, K4OJ k4oj at ij.net
Wed Apr 8 00:19:54 EDT 1998


The TH7 uses the same boom to mast bracket as the 204BA ( think )....

That has a flat vertical plate which another aluminum plate that is bent
into a "U" shape mates with, capturing the boom between them.

Why not mount this flat surface against the existing flat surface of the
Bertha pole's plate?  Flat surface to flat surface is the combination least
likely to screw up....and since the beam is already QRV for the
manufacturer's hdwe minimal other work would be necessary...

Eliminate the two toothed cast pieces of the original boom to mast assy
from the equation....(give you ten bucks for 'em Scott)....

Mount the HyGain hardware to the boom such that you will end up with a flat
vertical surface (you may need to change over to a flat head/countersunk
screw versus a machine bolt to do this on the hdwe which holds those two
aluminum shapes together.

After doing this use the location of the holes which would have held the
four long bolts, that would have gone through the two cast pieces, as
locations for where you need to put four holes in the existing plate on the
Bertha, then mount the two 

plate to plate 

with four bolts .....voila.

I understand you are getting your station ready for the next contest,


the Florida QSO Party!


73, see you in the FQP

Jim, K4OJ

Florida Contest Group - visit our website at:

http://www.4w.com/deemer/fcg.htm

What's an FQP? The Florida Contest Group is pleased to announce the
rebirth of the Florida QSO Party, check out the FQP website@:

http://home1.gte.net/wd4ahz/fcg/ssqp.htm


--
CQ-Contest on WWW:        http://www.contesting.com/_cq-contest/
Administrative requests:  cq-contest-REQUEST at contesting.com



More information about the CQ-Contest mailing list